Skip to main content

I just hooked up my TPC300 to one side of my MTH Z4000. I can not now operate this side in conventional mode, using the control lever of the Z4000. Is there a bypass on the TPC300 or is the only option to running in conventional mode through my Cab-1? I have not found this topic address in the setup literature.

Original Post

Replies sorted oldest to newest

Dale,

Just to make sure I understand; your saying to run a jumper wire from the hot power in terminal of the TCP over to the hot "A track out terminal" with the switch inserted in the jumper wire?

I'm assuming that the jumper wire switch is "OFF" when the Cab-1 power is in operation mode. When the Cab-1 power (mode) is shut down, then the jumper wire switch if "flipped" ON allowing power to bypass the TPC...allowing conventional operation.

 

Sorry, I'm kind of slow to absorb this sort of info...but...thanks to you pro's I'm getting there.

Post
×
×
×
×
Link copied to your clipboard.
×
×