Ran into a glitch today using the upgraded app. I was adding extra engines even though the app can't run them together. I figure I'd have them loaded anyways. I was adding my fourth or fifth engine to the app. It's a MTH dash 8-40CW NS. It added OK to address #3 which was unchanged I think from where it was in the remote. I started it up OK and it ran. There was no horn or bell? This engine was last used in consist and those would have been muted. As I looked thru the app for the sound controls I noticed the app had reverted to the last engine run and listed it as inactive? I scrolled to the engine list and there was nothing listed for the NS in #3? I re-added it and that worked. So I was trying the feature reset of the engine and it seem to work as the volume went to full? But the engine was gone again?
So I re-added it once again and turned the volume down. I pressed the horn and bell and they both were still silent? The engine ran back and fourth OK and it shut down when asked to.
I added another NS -8 narrow nose and that went as expected after the incident.