Hello I would like some advise.... I going crazy here with this.
I developed a problem best seen on the video. I have 2 MTH Z 4000 wired 1-2-3-4 from left to right, I connected 1-2-3-4 to the DCS in the same fashion 1 to var 1 , 2 fix 1, 3 to fix 2 , 4 to var 2. I have a Legacy connect as well.
I was loading the MTH Engines and My wife move a car and made it short of the track by not placing it correctly on the track. It took a while for us to find it. After which we has this issue.
When I apply power from one transformer the other transforms shows the power. http://zigmont.com/IMG_0683.MOV
Does Any body have a cue??
I have done this test and all tested fine.
I have the DCS channel on
Disconnect all wires from the TIU.
Put power into Fixed #1 In. The TIU’s red LED should light up.
Set Variable #1 and Variable #2 to Fixed Mode: Menu/System/DCS Setup. Select Variable #1 and press FXD soft key until the message comes up that says the channel is in Fixed Mode. Repeat for Variable #2.
Test the output of Fixed #1 for voltage.
Leaving power into Fixed #1, put power into Fixed #2. Test the output of Fixed #2 for voltage.
Leaving power into Fixed #1, put power into Variable #1. Do not press TR the button. Test the output of Variable #1 for voltage.
Leaving power into Fixed #1, put power into Variable #2. Do not press TR the button. Test the output of Variable #2 for voltage.