Adding TMCC engine to DCS wifi ap

Choose or add an engine at the top of the screen. On the next screen scroll down to add engine then select tmcc engine

You bet did that the ap does not see my tmcc engines

DCS doesn't ever "see' TMCC or Legacy y engines, either from the remote or the app. You have to enter them manually.

After manually adding my TMCC engines, they start up and run fine with my iOS device. But then if I hit the refresh symbol at the top of the screen, all TMCC engines go to the inactive list, even if they are still running.  I am not able to activate them again unless I delete them and manually re-enter them again.  I am using the same address for each as displayed on the MTH hand held remote - that is correct, right?  What am I doing wrong?  Any ideas? 

Rob,

That is normal behavior.

An app Refresh is exactly like a remote Read. It sorts engines it can see on powered tracks into the Active List and those it cannot see into the Inactive List. Since TMCC or Legacy engines are never seen because the cannot talk to the remote or the app, they always go to the Inactive List.

To move any engine form Inactive to Active, do the following:

• Ensure that the engine is on powered track.
• On the Engine Roster screen, tap Edit.
• Use the slider to the right of the engine to move it up from Inactive to Active.
• Tap Done.
• Return to the Engine Control Screen and operate the engine.

Barry Broskowitz posted:

Rob,

That is normal behavior.

An app Refresh is exactly like a remote Read. It sorts engines it can see on powered tracks into the Active List and those it cannot see into the Inactive List. Since TMCC or Legacy engines are never seen because the cannot talk to the remote or the app, they always go to the Inactive List.

To move any engine form Inactive to Active, do the following:

• Ensure that the engine is on powered track.
• On the Engine Roster screen, tap Edit.
• Use the slider to the right of the engine to move it up from Inactive to Active.
• Tap Done.
• Return to the Engine Control Screen and operate the engine.

Barry, that worked - thanks so much for your help!