Hello everyone, just purchased the mth beacon light. The light wasnt spinning so I took it back and got another one, 2nd one doing the same thing. Anyone experience this and have any suggestions. Thanks.
Original Post
Replies sorted oldest to newest
Did it have the rubber finger ring under the light? What voltage did you use?
Around the light is a rubber washer with little dimples, is that what you mean?
Yes. That is good. What voltage did you try? Did your dealer try it?
I will have to check the voltage I have three voltage slots its on the highest. Yes the dler tried it, it worked there but only tried it for a few minutes. When i turn it on it works for a while but eventually stops until I touch it to get it going, will work for a bit then stop again.
A little powered graphite to the flat side of the washer around the base of the lamp socket should get it going.
So remove the rubber washer that has the little nubs...apply the graphite directly to the base around the light, put back rubber washer and thats it?
