Skip to main content

Does each channel send out a watchdog signal when it gets voltage at any time, or does the DCS only send out a watchdog on all channels when first powered up?  I have my TIU wired live via the AUX input.

 

I just installed a set of PSX quick circuit breaker boards for each loop (see https://ogrforum.com/d...ent/3259945169936428 for details.)  If I have a track short, the PSX will instantly cuts off power.  If I reset the breaker, would the "dead" channel rebroadcast a watchdog upon getting its power back again, or will engine come up conventional?

 

Original Post

Replies sorted oldest to newest

Sam,

Does each channel send out a watchdog signal when it gets voltage at any time, or does the DCS only send out a watchdog on all channels when first powered up

Yes.

If I reset the breaker, would the "dead" channel rebroadcast a watchdog upon getting its power back again

Yes.

 

This and a whole lot more is all in "The DCS O Gauge Companion 2nd Edition", now available for purchase as an eBook or a printed book from MTH's web store site! Click on the link below to go to MTH's web page for the book!

 
 
Post
The DCS Forum is sponsored by
×
×
×
×
Link copied to your clipboard.
×
×