Last night, I was running an engine that hasn't been on the track for awhile. The DCS remote located it and I ran it for awhile and everything seemed to be fine. But then I discovered that when trying to get it to go through the sequence of dialog, it was stuck on the first message. What can I do to access the other dialogs in the sequence? The engine is a Scale K Line Hudson that has PS2 installed in it.
Roger
Replies sorted oldest to newest
did you hit the red direction button on the remote each sequence plays for about 30 seconds then you hit the direction button and changes to the next sequence if I remember correctly there are 4 sequences before it returns to normal operating .
p.s. not sure but I believe that you could reload the sound file for that engine not sure if the sequence is in the sound file but believe it is. possibly others will chime in and confirm!
maybe your sound file got corrupted somehow?
what is the sound file installed?
If you post the link to the installed sound file, just maybe someone can download it and check for the sequence files.
bruce
I think the problem is, I may have been hitting the wrong remote button to advance the sequence. I haven't used the dialog feature of my engines for quite awhile. I'll have to go down there and boot up again and try it.
let us know what you find out ok!
Alan.........my fault. I was hitting the wrong button to advance. I rarely use the dialog and it showed. Thanks! All "fixed".
Access to this requires an OGR Forum Supporting Membership
