I noticed in my handheld remote...each of the GP9s that are a part of my GP9 lashup are listed...along with the lashup..in the active locomotive screen of the DCS remote. See Photos.
Is this normal...I thought the members of lashups...dropped to the inactive list when a part of the lashup.
I am sure I am just being dumb again...but, any kind response is appreciated.
Replies sorted oldest to newest
Typically,
Typical ash behavior is::
However, if you bring a member engine into the Active list and do not start it up, the lashup will not go Inactive.
Regardless, just ignore the situation. It's a non-problem. 
 | This and a whole lot more about DCS is all in MTH’s “The DCS Companion 3rd Edition!" This book is available from many fine OGR advertisers and forum sponsors, or as an eBook or a printed book at MTH's web store! |
 | This and a whole lot more about DCS WiFi is all in MTH’s “The DCS WiFi Companion 1st Edition!" Get the free TMCC & Legacy Addendum here! |
All of my 3 MU's/lashups(5 all powered in each MU) stay in the active list..none are in the inactive list. All engines maintain their individual settings. This is in a DCS 4.2 environment. All engines are ps3 and ps2 3 volt.
Access to this requires an OGR Forum Supporting Membership
