Skip to main content

Replies sorted oldest to newest

@amtrack5899 posted:

How do you delete an engine from the legacy base/remote.  I accidentally programmed 2 engines with the same ID no. I know in DCS they have a special key for adding and deleting engines.  I do not know if lionel has this delete function.

Just use the PGM/RUN procedure and give the engine a new ID and then enter it's info into that address on the Legacy system.

If you want to remove the information from a particular address on the Legacy base, select that ENG #, push info, and then push CLR.

The Legacy system has "99" addresses for engines.  What ever ID number you assign to the engine using the PGM/Run procedure occupies that address.

So if you sell and engine, go to that ENG in the Legacy base and push info and then clear.  The address # in the Legacy system stays but clears out the engine data so when you add a new engine into that address you can add it's information.

Last edited by MartyE

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×