Skip to main content

Replies sorted oldest to newest

gunrunnerjohn posted:

I'm assuming you're talking about the Mini Commander II, right?  If so, it has no whistle output in command mode.  You can, however, tap off serial data to run a command compatible sound board.

I am talking about the Mini Commander HC. I have been thinking, could it be used for running a smoke unit fan for a small amount of time as it has adjustable pulse configuration.

I believe you are talking about the Mini-Commander ACC (Accessory) High Current board, which is primarily designed for certain accessories like the log loader. It will support a smoke unit on HC1 or HC2 but I don’t think you need the high current support for that. I notice however that you only mention running a fan motor for brief periods, which again I think this or probably any other Mini-Commander board can do. Check the manuals on the 3rd Rail/ERR website for the full range of applications.

P.S. GRJ mentions the serial data output but my last experience with a MC was that it would not drive sound output on ERR’s own latest Sound Commander boards whereas ERR’s dummy engine board would. I don’t think that's been changed since ERR was taken over by 3rd Rail but I stand to be corrected.

Last edited by Hancock52

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×