Skip to main content

Replies sorted oldest to newest

Which screws are you looking to replace? The screws that hold the motor onto the frame, or the screw studs that hold the brushplate in place?

If you are looking to remove the field winding from the motor housing, unscrew the 2 slotted nuts from the brushplate, unsolder the field wire from the tab on the motor, remove the brushplate, and pull the motor field out.



Larry

Add Reply

Post
This forum is sponsored by Lionel, LLC

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×