Skip to main content

I have a 2031530 vision line GS4 that will stop while running under legacy control. None of my other engines do this on the same track. When this happens the headlight starts flashing/flickering. I found that if I touch the handrails the headlight stops flickerinng and I can control it, but it will stop again quickly when I let it run. It also has trouble with Bluetooth.  

From what I've been able to read it sounds like the antennas disconnected or the receiver is bad. I can send it back to Lionel but that will probably take a long time.

Where can I find a parts breakdown?

How hard is it to change out the receiver?

Original Post

Replies sorted oldest to newest

@Kmaple posted:

I have a 2031530 vision line GS4 that will stop while running under legacy control. None of my other engines do this on the same track. When this happens the headlight starts flashing/flickering. I found that if I touch the handrails the headlight stops flickerinng and I can control it, but it will stop again quickly when I let it run. It also has trouble with Bluetooth.  

From what I've been able to read it sounds like the antennas disconnected or the receiver is bad. I can send it back to Lionel but that will probably take a long time.

I wouldn't suspect the antenna connection since you are coupling the signal with your hand with the antenna.  If the antenna was disconnected, it wouldn't have any effect.

First thing I'd try is to lay an earth ground wire next to the track in that area and see if that cures it.

@Kmaple posted:
Where can I find a parts breakdown?

How hard is it to change out the receiver?

Probably nowhere, it's not on the Lionel parts site.  The receiver is part of the RCMC board, that's an expensive swap.

Add Reply

Post
This forum is sponsored by Lionel, LLC
×
×
×
×
Link copied to your clipboard.
×
×