Skip to main content

I am using a Base-1L with CAB-1L to operate my fastrack switches.  The base is wired from its Track U binding post to a common (black) 14 volts terminal on the Z4000 transformer as recommended by a Lionel tech on the phone. Same channel on CAB remote and Base. Using DCS for the layout. I started programming with ID #1. To confirm I followed the manual, but when I press SW#1...Aux1 or Aux2 all 24 switches respond to the command. I programmed SW#2. That worked fine. How do I get SW#1 only to respond instead of all the switches responding with SW#1 ? Thank you.

Last edited by luvtrains
Original Post

Replies sorted oldest to newest

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×