Skip to main content

Why am I not surprised, I followed the steps in the instruction manual, and when I finished I set it on the track to set the engine ID and the feature code, and of course turned the power on and nothing happened, no lights, no response, nothing.  Any thoughts on what I may have done wrong?
Last edited by Landon Eshbach
Original Post

Replies sorted oldest to newest

Until you ID it and set the feature code, it may not do anything. Not even an indicator blink.
Could be as simple as the light is not working.
Try it on a conventional loop if you have one.

And believe it or not, my command engines will not run in conventional upstairs on my still set up Christmas loop. ( I know, at least I took the tree down)if my Command base is still on downstairs in the basement.
Good luck.
Post
×
×
×
×
Link copied to your clipboard.
×
×