Skip to main content

I have been meesing with a problem for a while. I have a legacy Lionel K4 that runs and sounds good on the entire layout except one spot near my Ross 11 degree crossing. the sound stops when going over one route. it is wired up with a DZ1000 to keep all the track sections live for which ever route the train is on but the sound drops out. if I stand next to the crossing to trouble shoot it goes threw with no interruption but if I back away it will fail every time. I am guessing it's losing the signal. any ideas on how to correct this.  I also have a weaver 2-8-2 that will  do it occasionally .   thanks Rick

ck

Original Post

Replies sorted oldest to newest

thanks the battery did the trick. I assumed the battery was a thing of the past and not an option on legacy locos. an interesting thing though if you put the battery in the tray on top of the speakers that looks like its designed for it you cannot put the tender shell back on as the screws that hold the coal load are in the way.  

@Norton posted:

Lionel Railsounds typically use non rechargable batteries. There is no on board way to recharge batteries. They typically last about ten years though.

Pete

I've had Duracells leak after a couple years BEFORE they go out of date or charge. Very annoying, but not in an engine yet. I took all the non rechargeable batteries out and am just relying on the YLBs when desired. I find the Energizers good so far and even better the Energizer Lithium batteries. Expensive though, but worth it if the item you put them in is seldom checked or expensive.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×