Skip to main content

Replies sorted oldest to newest

Hey guys, I have had the legacy system v1.4 for about a month...rel 100 is in there where the blank on gunrunnerjohns screen shot shows.  Did not know much about it but my older tmcc diesels and atlas o diesels seem to run the best with it.  On the screen though you lose the momentum graph when you dial in rm100.  I think it is 100 speed steps.

Well, I managed to get it into REL100 mode, but it was uninspiring.  First off, when you go to select it in the LSU, it says REL100 (unsupported), doesn't exactly inspire confidence.

 

I selected it anyway and fired up the locomotive.  It had all sorts of issues.  It wouldn't go into reverse, even though the directional lights changed!  It would only go forward.   It also lost all the TMCC enhancements anyway, so I might as well run in CAB1.  That at least works.

 

This was a standard TMCC locomotive with the ERR Cruise Commander M, I'll have to try it with the ERR Cruise Commander stand-alone board, but I don't hold out much hope.

Post
×
×
×
×
Link copied to your clipboard.
×
×