When connected to power source and controller, table will move only in one direction. Tested motor separately and it works in both directions when powered directly. Any thoughts/suggestions. Thanks. Tom LoPresti
Make sure that the controller wires go to the correct control rails. Then turn the table over and check the spring loaded contact. They need to be clean and have a good spring. The control rails also need to be clean. If you are using an extension, it only goes on one way and the pins have to be clean and tight.
David, thanks for the info. When I checked the underside of the table again, I noticed the yellow wire had come separated from terminal. Re-attached and all works fine now. Thanks again. Tom LoPresti
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
Access to this requires an OGR Forum Supporting Membership
OGR Forum Supporting Membership
Help support this forum with an OGR Forum Supporting Membership. You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM! A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!
OR
Access the ALL the OGR VIDEO FORUMS ANDover 300 back issues of OGR with a DIGITAL SUBSCRIPTION!