Skip to main content

Have a legacy gp7 28561, when I turn track power on it addresses correctly sits there as soon as I touch the throttle it takes off full speed no control .I know its a problem with the engine itself because all others work fine. reset it a few times still same thing, any suggestions? thank you

Last edited by scottyhubcaps
Original Post

Replies sorted oldest to newest

I have the same thing happening with a Legacy F7.  There was a derailment which resulted in a trip of the ZW-L transformer when this happened.

So it is obviously something in the PCB's (printed circuit boards). The F7s have two, and I anticipate that one or both PCBs need replacing.

A Lionel Authorized Service Center had them for several months and could not ID the issue.  They seemed competent (the guy is a graduate electrical engineer) and I have confidence he tried his best and would have found the problem, but he didn't.

I will take them to another service center.  The F7 set (1 powered, 1 unpowered) are my favorite engines.  With near $1000 invested in them,  I think (depending on the total cost), I would pay to fix them.  Ugh.

Last edited by Mike Wyatt

The bad news is, the top suspect is the DCDS-J MTR DRIVR BRD(S05 CODE) /OBSOLETE, Lionel declared all of those parts obsolete and removed them from the parts site. It could be the tach sensor or the wiring between it and the DCDS as well.

Your best bet is find someone that can possibly repair the board, many times this is one or more of the driver FET's.

Add Reply

Post
This forum is sponsored by Lionel, LLC

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×