Skip to main content

Hello All,

The magnet strength is good if you run the crane at a higher voltage, but then the "swing" movement is too fast.

There was an old post about replacing the two resistors at the "swing" control lever to slow down the swing movement, thus allowing the crane voltage to be set higher.

What size resistors would I need?

Has anyone tried this, and if so, any pointers on installation is appreciated.

Thanks,

Vic

Original Post

Add Reply

Post
This forum is sponsored by Lionel, LLC

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×