Skip to main content

I have many of the great Miller Engineering signs on my layout.

My latest is the small version of the Good Humor Ice Cream sign.

Since most of the small version of the signs do not come with a frame, I developed the method below to install and raise up the sign an inch or so from the layout top:

Starting with a small leftover piece of a foam block wall (from Scenic Express):

B0432F2E-F785-449B-B34C-AAB24F15822C

Next - Using an Exacto knife, I carved out a rectangular hole from top to bottom to push the sign connector into:

IMG_1084

Next - I made an opening in the table top to push the sign connector through from underneath:

IMG_1092

Next: I tested the block wall support to insure a snug fit of the sign connector:

IMG_1085

Next: I secured the sign controller under the table top, wired to the Miller 4.5 DC volt terminal strip and installed the sign into the connector. Here are the front and back views:

IMG_1093IMG_1100

Attachments

Images (6)
  • B0432F2E-F785-449B-B34C-AAB24F15822C
  • IMG_1084
  • IMG_1092
  • IMG_1085
  • IMG_1093
  • IMG_1100
Original Post

Replies sorted oldest to newest

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×