Skip to main content

Again it may be in bad judgement but...

 Am repowering a MTH PRR Decapod with a dead PS2 5V board with the compenents from a PS2 3V steamer.  To complete this project I need the pinouts.  I would also like to properly length the wiring without splices or wire nuts. so I need to know the correct molex connector sizes to purchase.

Used Railking locomotives typically can be sourced for less than the upgrade kits so I am being pennywise hoping my skills will prevent me from being pound foolish.

Original Post

Replies sorted oldest to newest

Add Reply

Post

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×