Is there a way for me to change an engine's name permanently, even after a DCS reset? I just got an engine back from repair (dead 5v board) and the board (new/used 3v board w/5v connectors) was apparently swapped from another engine. I found this out after I performed a reset. I know I can change it in the remote, but I would prefer to make the change permanent, especially since it's a steam loco with a diesel name and that I sometimes reset the engine to run with a DCS remote commander. I also have a diesel that I've replaced the shell on, and now the road name and number are different. From what I've read, this can be accomplished using the DCS dealer loader software, but I don't have access to that. Any way for me to accomplish this myself?
Original Post
