Skip to main content

Looking for suggestions to power the relay's in my ASC2s. Currently hooked up to a Lionel 1033 Transformer on the variable 16 volt terminals. Thinking about using a fixed voltage (12 volt AC) like the one below from Amazon so I don't have to be concerned about power over the 12-14 recommended for the ASC2

I have two ASC2s and a BPC2.

Suggestions?

https://www.amazon.com/dp/B00W...b3RMb2dDbGljaz10cnVl

Original Post

Replies sorted oldest to newest

Please. Be patient, I’m new with electronics but learning. If I opt too use an MTH Z500, 750 or 1000 do I need to use the MTH controller to make it regulated as dougklink mentioned or can I just cut the plug off the low voltage side and hook it right to my ASC2. Not sure about the output voltage of those MTH power supplies.

Thank you everyone for your suggestions.

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×