Forum is there a rattle can paint color close to the pullman green we use on our models. I just do not like paying $5 and up for ounce of paint.
Replies sorted oldest to newest
Most rattleeeeeeeeeeeeeeeeeeeeeeeeeeeee cans are now 9.00 per can
Bob
Try KRYLON short cuts....3oz can less then $4.00...don't know if they can match Pullman green but they have a large selection.....can be used on plastic....
FWIW Every train manufacturer seems to use a different shade of Pullman green as does every paint brand. I have yet to find any that are are an exact match either paint or car brand. If the color chip looks close, buy it. If you are trying to match a particular car, good luck.
Pete
Yeah. And the major brands are now one-time use, and throw away all that paint that you cannot get to.
i used to love Krylon. That went bad, and then I fell in love with Rustoleum. I have wasted so much Rusoleum in the last two years that I am tempted to bundle all the cans I have and ship them to the CEO.
I am currently having good luck with Dupli-color (Pep Boys).
As to Pullman green, you need an airbrush. Scale Coat has about four flavors - my favorite is GN Green. Try a Paasche model H and a cheapie compressor. Not difficult.
bob2 posted:...
As to Pullman green, you need an airbrush. Scale Coat has about four flavors - my favorite is GN Green. Try a Paasche model H and a cheapie compressor. Not difficult.
While I can't vouch for the color (haven't used it yet), I can definitely vouch for the air brush. My compressor was $160 including the regulator and water trap. You didn't say what you were painting, but note that at Bob inferred, there are different "Pullman" greens used by different roads. As I recall, Santa Fe's was significantly lighter than the green MTH uses on their cars.
As stated, there's Pullman Green and then there's Pullman Green. Different shops did their best to match what came off the assembly line. If you're near a Home Depot, they have paint sample board 6010-3 Olive Suede which is pretty close to Pullman Green. Not Lionel's rendition, not MTH's rendition, not K-Line's nor Williams. Pullman Green as it came out of Pullman, Illinois John in Lansing, ILL.
Scalecoat II S2017 Pullman Green in 6oz rattle can. Yup 10.00 a pop. Over time Pullman used as many as 7 variations ranging all the way to a very brownish shade. Mix in road variations and you could call just about any shade "prototypical".
Pete S
Thanks for all the reply's. I have and can use an airbrush. My complaint was the cost of the paint, for such a small quantity. When I buy a rattle can of paint ,its for the ease of not having to mix and thin the paint. I usually spray it into a large paper cup and then add it to my air brush to get the control the air brush allows. I must say that this forum is a great place to get advice on what to use and how others are using and doing things. As old as I may be, I am still learning from some of you folks. I do Thank you all !
Franky-Ogee
Franky-Ogee, Home Depot will mix a sample can of latex paint for you for less than $5. I think it is one cup in size. John
I have used Scalecoat (now Minuteman Models) lacquer based Pullman Green and have been well pleased with it. It is darker than the color Floquil used to call Pullman Green and is a dark rich color. I purchase my paint in 2oz bottles and use an air brush to paint...no "rattle cans". The Scalecoat paint dries with a gloss when baked on in an oven at 175F for an hour and is a good surface to apply decals on. Thinned per the instructions on the bottle for air brushing you can paint several models with one bottle of paint. Now if you are trying to match a "factory painted" model made overseas this color may not work for you but as someone above said, "Pullman Green" varies.
Joe Foehrkolb
I use almost exclusively ScaleCoat II and have for years. I have tried others but stay with it. Dries gloss for decal work.
Dick
The final color will also depend on the undercolor/primer color you use