I have three power districts each with its own brick and powermaster programmed into my remote as 'tracks'. When I address two of the 'tracks' there is no heading in the display other than the name I programmed. However the third 'track' always comes up as 'CAB 1' in the display. Does anyone know what is going on? Note the only locomotive I have on that track is Legacy and it is programmed Legacy.
Thanks
Joe
Replies sorted oldest to newest
Call up TR -1, press info, scroll past name page, change mode to "TMCC".
@choochoopaul The Cab-2 doesn’t work that way for TR addresses. There must’ve been something else programed into TR3. Typically I’ll have issues with it thinking there is a train in TR 1 and doing the same thing. You need to @Joe Fauty you need to hit info and then clear all information for TR3 and it will go back to normal CAB1 mode
Keep in mind, your track isn't powered as TMCC or Legacy, only the locomotives are.
I agree with Zachariah, TR3 must be mis- programmed or not at all. The Legacy handheld default is "cab1" mode.
Thanks guys - took all three advice. I re-programmed the powermasters as ENG and set them to Legacy/RS5. Every thing seems to be working again. I also found out that with legacy version 1.3 or higher it is advised to use TR 10 or higher as 'programming a lower number will result in unexpected operation'
Access to this requires an OGR Forum Supporting Membership
