Setting stall on legacy engine with TMCC?

If you are using a CAB-2 Don't set the stall if all the engines are legacy, all legacy engines are set to run the same.

Even a switch engine will change gearing when included in a MU

If using a CAB-1, not sure if you would have to either

The procedure in Legacy control is press the set button (the headlight will flash).

Get the engine rolling

Turn the throttle counter-clockwise until your engine just stops

Press the set (headlight will stop flashing, engine will stop)

If the headlight doesn't flash after pressing the set button Stall is not supported on the engine. I believe the stall feature is primarily in pullmore motor engines. I haven't had my Legacy engines out in while (building layout only running cheap stuff) so I can't remember using stall on them.

Ron

Stall has no meaning for Legacy with Odyssey II, so I'd be surprised if it was supported.  OTOH, there are Legacy locomotives with A/C motors, I suspect stall may be supported in those, but I don't have any to test.

These are all legacy with odyssey 2.  I am running with a tmcc cab-1 and all 3 of them run at slightly different speeds. 2 of them are the exact same engine with different shells. If i cannot set stall, is there anything i can do to make these work better together in lash up?

I've never experienced the issue of two identical Legacy engines running at different speeds for the same setting.  What does Lionel say, that sounds like a problem.