Skip to main content

Replies sorted oldest to newest

I'd seriously consider a separate TMCC controller in the second locomotive.  My experience with the standard TMCC drivers and four motors has been mixed.  The fact that you have steep grades will put an additional load on the drivers, I don't think I'd want to have one driver board running them all.

 

Are these AC or DC motors?  What's the specific model and/or cab numbers?  Do the dummy trucks actually support the addition of motors?

This is set number 60-317550-00.  E-7 power.  I have also sent an Email to Lionel service about the same question.  I have not opened the unit yet to see if the gears and such are there.  You do raise a good point.  Could I use an ERR board to control the extra motors along with the TMCC i the main power?

Post
×
×
×
×
Link copied to your clipboard.
×
×