Skip to main content

Got my new Railking PS3 Train Master today and tried to program it into the TIU remote.

I do have a programming track and after several error messages (even though I was standing within 2ft of the TIU) it finally took.  Somehow my PS2 SD35 took as well.  At one time the SD35 responded to the FM commands and the FM to the SD35.  I deleted both and started over.  Now I have a (C) on the remote for both engines, but they seen to run fine. 

The FM markers are backwards as red to front in forward and to the rear in reverse.  Somehow all the lights got turned off as well.  

I've tried the soft keys for markers and control key for headlight with no result.  Ultimately I want the Mars light off as well.

I've looked through the MTH DCS book and Barry's DCS book, I'm sure the answers are there but I can't find them.

Out of RF range - weak battery's even though no message and all seem to run OK.  Would a reset restore and correct the lighting and marker direction.

Thanks

Gray Lackey

 

Original Post

Replies sorted oldest to newest

"

The FM markers are backwards as red to front in forward and to the rear in reverse.  Somehow all the lights got turned off as well.  

I've tried the soft keys for markers and control key for headlight with no result.  Ultimately I want the Mars light off as well."

If you can't turn the lights on with the softkeys, sometimes are feature reset should restore it.  

Were the red and green marker lights always reversed?  If so, it may be a physical problem.  I had this happen years ago, and the plugs were swapped on the board at the factory.  It was pretty easy to swap them to the correct positions.

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×