Skip to main content

hello. i hope this has not been mention before if so give me a link. anyway, i have a legacy engine which a gave it number 90 on my legacy remote. i also gave a number to my culvert unloader which was 45. now, the other day my legacy engine would not respond to commands, so i changed the number and it started working. today the same thing happened to my culvert unloader. changing the number made it work. what is going on with my legacy system? 

Original Post

Replies sorted oldest to newest

hello john. the command system is the full legacy. i have the up 9000 set in the controller as tmcc. however, i just checked the culvert unloader and found it was not set as tmcc. set it up as tmcc and it works with the old number i put in. learn something new every day. i thank you again, john, for opening my eyes in the complex electronic world. 

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×