Skip to main content

An engine shorted on a switch in my engine yard on fixed2 block with tender spanning onto the Var2 mainline.  The Z4000 red light came on, I powered down, I moved engine out of the way.  Powered back up,  I then back a ps2 engine out from the yard (fixed2) under command control onto the mainline (Var2) and then noticed I have no control, no dcs signal on the var2 mainline, but engine is running (run away actually).  Powered down, open tiu, check the fuses, all ok, put together, now var 2 is completely dead, no power at all.  Fuses are seated properly.  Rev. L tiu, channels set to fixed, on, on, fixed, both Z4000 handles have power.  Suggestions?  New tiu needed?  Thanks in advance.

Original Post
Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×