Problem with Weaver Little Joes & DCS

Did you  entered the correct TMCC address to the DCS remote (that's the Address you use with the cab-1 )  after naming the engine?

First you name the engine, and hit the "D: for done and then the list of TMCC addresses comes up. This is the  same address  to add  when  using the   cab-1.  The engine will add yto the inactive list.  Select to make it active and select again to bring up on the screen.. Press start up. Can you blow the whistle , fire the coupler? how far can you get??

Side question, how do you like the Weaver Little Joes?

illinoiscentral posted:

Side question, how do you like the Weaver Little Joes?

I like them a lot.  no problems.  Good haulers.

Gregg posted:

Did you  entered the correct TMCC address to the DCS remote (that's the Address you use with the cab-1 )  after naming the engine?

First you name the engine, and hit the "D: for done and then the list of TMCC addresses comes up. This is the  same address  to add  when  using the   cab-1.  The engine will add yto the inactive list.  Select to make it active and select again to bring up on the screen.. Press start up. Can you blow the whistle , fire the coupler? how far can you get??

Yes, but I will double check this afternoon.  Like I said they work fine with TMCC.  Nothing happens with DCS

TMCC Base connected to the TIU?

I have exactly the same problem with my Weaver Little Joe. It runs fine with CAB-1 and will reverse and have horn and bell sounds with the DCS but will not resond to any command from the DCS to move. I've re-enterd it into the Hand held (twice) but with no result. It ran before on the DCS but was inactive for a while. Any ideas?

John, make sure it has the same engine number on both remotes.  I just prefer to use the Cab 1 for the Little Joes, Everything else goes through DCS.