Hi all, does anyone know if the upcoming Base 3/Cab 3 system will interface with the LCS SensorTrack, or do I need to find a Cab 2 system or Cab 1L?
Original Post
Replies sorted oldest to newest
@George Assad 070917 posted:Hi all, does anyone know if the upcoming Base 3/Cab 3 system will interface with the LCS SensorTrack, or do I need to find a Cab 2 system or Cab 1L?
Yes . Cab3 and Base3 will work with sensor tracks just fine.
Yes. All you need is PDI cables to connect any LCS device. The Cab 3 base has 3 PDI ports and you can daisy chain multiple devices attached to each port. No separate power supply is needed. Here is an excerpt from the Base 3 manual:
LCS with the Base 3
Lionel’s Layout Control System, or LCS, allows full layout control of things like operating accessories, switches, track power blocks, and more. The Base3 expands the usability of LCS by including three PDI connector ports. Each PDI port operates independently, and they all communicate to the Base3’s main processor, so having a single daisy chain with all LCS modules is no longer needed.
CONNECTING BASE3 TO LCS MODULES
With the Base3, the LCS DB9 Cable with Power Supply is no longer needed. Instead, LCS modules are connected to the Base3 by using a PDI cable. PDI cables are available in 1’ (6-81500), 3’ (6-81501), 10’ (6-81502) and 20’ (6-81503) lengths.
BASE3 PDI POWER
The Base3 provides 12V DC PDI power to each LCS module. The green LED above each PDI port on the Base3 indicates that the PDI power is on for that port.Each port is rated to operate up to 10 LCS modules. That means the Base3 can handle 30 modules total. If your layout requires more than this, you may need to add an additional power supply tapped into the PDI line using a PDI cs-691JOINB00-p board. These are available on the Lionel Support page. In the unlikely event that a short occurs on one of the PDI lines that is connected, the Base3 will turn off power to that PDI output to protect both itself and the modules that are connected. The Base3 will monitor the status of that line and once the short is fixed or removed, power to that PDI port will resume. When a short occurs, the Base3’s “LIONEL” lights on the sides will blink to indicate a fault.
Bob
Thanks to all!
AFAIK, the intent is the BASE3 will be compatible with all the stuff that you used to connect to the Legacy base.
Thanks John, I can always count on you. I'm 67 years old and finally built myself a train room. I have a lot to catch up on!
@George Assad 070917 posted:Thanks John, I can always count on you. I'm 67 years old and finally built myself a train room. I have a lot to catch up on!
I built my current layout starting when I was 77. 
Obviously, it's not done, and my not be in my lifetime. 
@George Assad 070917 posted:Thanks John, I can always count on you. I'm 67 years old and finally built myself a train room. I have a lot to catch up on!
Maybe this will help you get up to speed a bit...
