DCS Remote Control Wiring

Problems are in a minority of cases.  When I got DCS 10 years ago, I simply dropped it into the circuit between transformers and layout.  I'm sure you've seen the pitches for Barry's book elsewhere on the forum.

Dan,

Any tips on wiring would be appreciated.

You might want to look at these threads:

First, this one:

https://ogrforum.com/d...ent/6216614250813807

Then, this one:

https://ogrforum.com/d...ent/6216614250922571

Dan;

Since you just got it, it should be a Rev L.

Just put it in line between the transformer and track. (Fixed 1 in and out)

Then go to the Far end of the layout and isolate the center rail there.

Run your Trains.

I run a 11' x 23' Figure 8 with 5 dead end sidings.

Even using an older DCS system I have no significant problems.

And I didn't even make the Isolation yet. I know it will fix my one weak area but am working on a total layout rebuild so I have not bothered.

And as above, I totally recommend Barry's book. It is THE BEST DCS help in existence.

Buy it on MTH's website or email Barry, he may have a few.

Rusell,

Buy it on MTH's website or email Barry, he may have a few.

Thanks for the kind words - they're most appreciated. However, I don't sell either version of the book directly. Both versions, print and eBook, may be ordered via MTH at this link:

http://www.mthtrains.com/content/60-1279