Skip to main content

Are the dedicated lighting circuits on the PS3 production board (NOT the PS3/2 board) current limited?

Or do I still need to include a resistor in line with any of the circuits driving LED's?  Specifically in the boiler board of the steam setup, I'm adding a firebox, number board and cab interior LED.  IIRC I think the Ps3/2 boards were NOT current limited, allowing the outputs (like for the headlight) to still drive a 6V incandescent lamp like for a headlight of the PS2 setup it was replacing.  But for the production PS3 boards, did they just go ahead and build current limiting into the card from the start?

Last edited by Jeff_the_Coaster_Guy
Original Post

Replies sorted oldest to newest

Add Reply

Post
The DCS Forum is sponsored by

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×