Fastrack center pins

Not sure if you can get the pins, but a jumper wire would be easy enough with the connection tabs on each section.

We have the same problem with the gorillas in my club the way they take fastrack apart at shows. Lionel does not sell the pins, tney want you to buy the track. The funny thing is I use fastrack at the shows that I do without my club and have yet to snap a track pin. It is not that hard to take apart. Only thing that breaks is the plastic snap-ons but not the metal pins!

We've been using pins from other used fastrack to make good ones.

Hey Lionel, want do you sell those track pins to the consumer?

I've had a couple of broken pins over the years, I just take them out of a scrap piece of Fastrack.  Whenever I get a rusted one, or one that's damaged, I pull the rails and save the pins.

BReece posted:

Can a wire be run from one piece of track to the next and the pin not be needed.

Thanks

Brent

Yes you can. Better if it's on a permanent layout.

Thanks for all the comments.

Lionel NOW sells the center pins, part number  

  Add $10.00 shipping

Again Thanks

Brent

They have the outside pins also.