Skip to main content

3 replies

Fastrack Unresponsive O60 Remote Switch Problem--SOLVED

John HJohn HOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBER

I have an unresponsive O60 switch. It was wired wrong at the aux in and track power, so I swapped the wires. Still no response. I ordered and replaced the motor controller board to no joy. There appears to be a resistor in the shrink wrap in the picture. I get 14M ohms on that red wire, 2 AC volts with 18 applied. I was wondering if anyone can tell me the resistor rating and or the voltage that should be at the 4 pin connector powering the board,Fastrack switch so I don't have to pull another switch to compare. That wire with the shrink wrap goes directly from aux in to the 4 pin connector.

Attachments

Show
Images (1)
  • Fastrack switch
Last edited by John H
Original Post

Replies sorted oldest to newest

Add Reply

Views: 206
Post

Membership Required

We're sorry. You must be signed in to continue. Sign In or Register
×
Are you sure you want to remove from your Block List?
×
Loading...
×
When you block a person, they can no longer invite you to a private message or post to your profile wall. Replies and comments they make will be collapsed/hidden by default. Finally, you'll never receive email notifications about content they create or likes they designate for your content.
Note: if you proceed, you will no longer be following .
×
Link copied to your clipboard.
×

Access to this requires an OGR Forum Supporting Membership

OGR Forum Supporting Membership

Help support this forum with an OGR Forum Supporting Membership.
You will be able to watch the videos in the INSTRUCTIONAL VIDEO FORUM!
A one-year OGR Forum Supporting Membership is only $12 per year, so sign up now!


    OR     


Access the ALL the OGR VIDEO FORUMS AND  over 300 back issues of OGR
with a DIGITAL SUBSCRIPTION!



$12.00 per 12 Months (plus tax if applicable)
×