My remote control switch, track is screwed down, just quit. I have auxiliary power supply. I checked the power and it was getting to the track but no switch light was lit. I took the plate off and everything looked fine, no loose wires.
Thanks
Replies sorted oldest to newest
Doesn't work in either direction? Have you tried throwing it manually by turning the lamp?
I had one where the limit switch under the turnout went bad, and it would work in one direction when turned manually to the other direction. The lamp in the switch control would go dead as well and come back on when thorwn manually.
Hi Bob
Did you check your Aux power source ?
the Aux power is for the motor to switch , The lantern may be tied to that when Aux power is used .
Good luck & let us know what the outcome is.
I checked the auxiliary power and have good juice through the wires and when connected. I thought at least the light would come on with the power
Bobo posted:I checked the auxiliary power and have good juice through the wires and when connected. I thought at least the light would come on with the power
Did you get this resolved? I have a switch that runs on aux power that has no power in the rails. Is that what you experienced?
Follow the rail power under the plate. It goes from tab to tab, and sometimes loses connection at the bend over tabs.
Access to this requires an OGR Forum Supporting Membership
