Skip to main content

The mailman just dropped off my transfer table that I purchased from a seller on Evilbay.   I purchased this to replace a post-war transfer table I presently own.  It is brand new.  I hooked it all up as per the instructions for conventional operation.  The table moves as it should.  However, the locomotive will not move when I press the appropriate button on the controller.  The light on the controller and the one on top of the hut will not light.  The accessory controller was pre-wired from the factory.  Although it's very difficult to see, the orange wire is connected to the clip under the bundle of wires held in place with a zip tie.  This orange wire goes to any power terminal on the transformer.  I ran a wire from the "U" terminal on my 1033 to the base of the transfer table to provide a ground.

 

Any suggestions would be greatly appreciated.    

IMG_8272IMG_8273IMG_8274IMG_8275IMG_8276IMG_8277

Attachments

Images (6)
  • IMG_8272
  • IMG_8273
  • IMG_8274
  • IMG_8275
  • IMG_8276
  • IMG_8277
Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×