I recently got this loco and test ran it with a late ZW and it worked fine. When I went to set it up for DCS Remote Control on the layout, the engine starts up in idle as soon as I turn the power on and the remote reads inactive engine on track. Consequently I can't get the remote to read it or reset it. Any suggestions would be appreciated.
Replies sorted oldest to newest
Check the following 4 things:
If any one of the above is not true, you will get the symptoms that you describe.
 | Everything that you need to know about DCS is all in MTH’s “The DCS Companion 3rd Edition!" This book is available from many fine OGR advertisers and forum sponsors, or as an eBook or a printed book at MTH's web store! |
 | Everything that you need to know about DCS WiFi is all in MTH’s “The DCS WiFi Companion 2nd Edition!" |
Barry, thanks very much for the advice. It's definitely in the simple things, after checking, I had the track connected to the #2 in/out on the TIU. That's what comes from working on your back under the table. lol
Access to this requires an OGR Forum Supporting Membership
