Skip to main content

Hello!

I have checked everything I can think of to get this thing (K-Line Berkshire K3670-1407TC) smoking again.  I replace the smoke element. It was a 20 ohm wire-wound resistor that I replaced with an exact replica.  The on/off switch shows the appropriate continuity and there is continuity "after" the PCB board (691-PCB1-0B9) - from switch to smoke unit so I figure I can rule out a broken wire.  The positive lead to the smoke unit resistor is insulated.   What I am not getting is any voltage (5 v DC?) on the +/- pins of the board when the locomotive is running.

Bad board?  Everything else functions perfectly.  I would be embarrassed if it is something simple, but I could bear it if I simply missed something obvious !

Thanks,

Dennis

Original Post

Replies sorted oldest to newest

Voltage to the smoke unit is actually around 12v. This engine has TMCC. Assuming you are running it in command try hitting AUX1 9. You can turn smoke on and off remotely using AUX1 9 for ON and AUX1 8 for OFF.

If still no smoke then the large triac o the R2LC is likely bad. Fortunately those can be replaced individually.



Pete

Last edited by Norton

Add Reply

Post
This forum is sponsored by Lionel, LLC

OGR Publishing, Inc., 1310 Eastside Centre Ct, Ste 6, Mountain Home, AR 72653
800-980-OGRR (6477)
www.ogaugerr.com

×
×
×
×
Link copied to your clipboard.
×
×