LCS to PDI cables?

laz1957OGR Forum Member SUPPORTING MEMBERMEMORIALIZED MEMBER

Hi GUYZ,

I just hooked up my first sensor track and it works great. The question I have is if I want to hook up more sensor tracks, I have three loops, all I need as the instructions say, is LCS to PDI cables in 20, 10, 3, and 1 foot lengths? I then daisychain them together, from the sensor track back to the power supply, leaving the last ST one female receptacle open. I have Fastrack with the remote switches, ones you have to flip with the remote and wire going to it. What would I need, LCS wise, for the use of these switches? Or do the switches have to be Legacy thrown switches? Also where is best price to get cables at? Thanks.

3/20/152:54 PM

❤️ 0

Original Post

Replies sorted oldest to newest

cbojanowerOGR Forum Member SUPPORTING MEMBERDIGITAL SUBSCRIBERMEMORIAL SUPPORTER

The cables daisy chain one to another, no termination needed on the last connection. As for the switches you would need a ASC2 to drive them

On my layout I have the power cable from the base connect to my WiFi unit, then using the 1ft cables my Ser 2, asc 1-4 and then it runs to my first sensor track. Then I jump from one track to another.

The ASC2 will control your switches but it does need external power. You will then run standard wire from the ASC2 to your switches .

3/20/153:00 PM

❤️ 0

laz1957OGR Forum Member SUPPORTING MEMBERMEMORIALIZED MEMBER

Thanks CHRIS. I have a SC2 that I have been using with Legacy Cab2 to power my accessories for some time now. This looks like the same type of setup only that it is hooked directly to the Legacy, is there any problem having this and the ASC2?

3/20/153:10 PM

❤️ 0