Hi all, my Legacy GP35 starts in reverse and when I press reset on the remote it still starts up in reverse. I also tried reloading the module. Any suggestions?
Thanks in advance.
Original Post
Replies sorted oldest to newest
Check your program and run switch on your engine. It should be in run.
It sounds like it may have been assigned in a train in the reverse direction. Assign it to train 'TR 0' using either TMCC or Legacy procedure and see if it resets.
what end of the locomotive is the f on along the frame? is it a high hood gp35?
If the unit was used in a consist running backwards, it may still think it's in the consist. Old TMCC, you had to assign the unit to TR (train 0). Legacy should have a similar procedure for UN-lashing or breaking a consist.
I agree with Mike CT. Whenever I have had this is issue in the past it was always with Legacy engines that were configured in a train in reverse direction. it was resolved by "UN-lashing" it.
Thanks for the replies. I'll try "un-lashing" it when I'm back home in two weeks. I will update then.
Sometimes that doesn't work .. If it doesn't delete the engine and reprogram it.. That will fix it
