My legacy Heritage SD70, 6-28377, diesel is dark and silent.
On power up in conventional the only sound is the smoke unit running. No lights, no sounds, no direction.
I do not have a command base or TMCC set up. Is there any magic wand or a procedure to get this
locomotive running in conventional?
bruce
Replies sorted oldest to newest
Was this a new engine?
Program switch in run? G
Program/Run switch - Run
This engine was purchased 'used'
bruce
Pull plugs and reconnect making sure contacts stay in holder. Reseat all boards if modular. After that it is test and swap to figure it out. G
GGG posted:Pull plugs and reconnect making sure contacts stay in holder. Reseat all boards if modular. After that it is test and swap to figure it out. G
Hey thats what i do !
bruce benzie posted:Program/Run switch - Run
This engine was purchased 'used'
bruce
Try it as Program then in case it is installed/wired backwards?
Access to this requires an OGR Forum Supporting Membership
