Probably not the right place to ask this question but I thought I'd try before I call Lionel for a RA repair.
Put the BB on the track after sitting idle for nearly a year. But.. it won't run in reverse. Forward is fine and all legacy features work perfect. It just won't run in reverse in command or conventional.
Anyone have an idea what could be the problem?
Also, anyone know how difficult it is to remove the shell and what screws to remove..
I'm thinking it could be a loose board
Thanks
Joe
Replies sorted oldest to newest
You either have your engine locked in foward or check your program/run switch. If the switch is in program it will run forward only.
You either have your engine locked in foward or check your program/run switch. If the switch is in program it will run forward only.
Thanks for your input but its not the problem. I actually had it run in reverse but it slowed to stop at a curve like it lost power. It also won't go forward when I try to go forward after its been in reverse. I'm thinking a bad or loose board.
Joe
Page #30 of the user's manual indicates where the body screws are.
Page #30 of the user's manual indicates where the body screws are.
Thanks for the tip. Amazing how easy it is to get inside that beast .. The engine looks so intimidating & complicated but four screws and the boiler top lifted right off the frame..
Unfortunately, I found nothing to fix so its off to Lionel
Joe
Access to this requires an OGR Forum Supporting Membership
