Skip to main content

picked this one up relatively cheap knowing it had an issue the unit runs foreward ok and cycles to neutral then when in what should be reverse it does not move. If you cycle to the next neutral then again it moves foreward ok again. Like the reverse polarity is not sent to the motors. A couple parts on the reverse board are a little toasty and i was going to try some component level but not sure where to start.

a new board is $25 but this is a v2 and i only see v3 at my parts guy. Anyone know it a v3 would work? Looks like it runs lights too.

 

thanks in advance electronic gurus!

Original Post

Add Reply

Post
×
×
×
×
Link copied to your clipboard.
×
×