That’s actually a “common” problem it pops up every now and again bout not all that often.

you can open the the bottom of the base and tighten the nuts. I had one completely break off the solder pad and had to re solder it but that the worse I’ve seen.

once the bottom is off it’s highly recommend to NOT flip the base over or the decorative greats from the top corners will fall out and can be a real PITA to get back in

What he said!

Other than the stinkin' inserts falling out, it's pretty straight forward.

@zhubl posted:

That’s actually a “common” problem it pops up every now and again bout not all that often.

you can open the the bottom of the base and tighten the nuts. I had one completely break off the solder pad and had to re solder it but that the worse I’ve seen.

once the bottom is off it’s highly recommend to NOT flip the base over or the decorative greats from the top corners will fall out and can be a real PITA to get back in

@zhubl, I thank you for the reply, I think I will leave it alone, I did manage to get the ring post a bit more snug and then I put a star washer with the twist nut finger tight, hope for the best,👍