Skip to main content

Hello all,

For a while I've been having this issue with my legacy remote. I have confirmed its the remote and not the engines because I added other engines with numerous addresses to the remote with no joy. 

 

It appears that directional control and speed graph become unresponsive, but the the thumb wheel is not. Horn and bell are also unresponsive. The bar graph line moves freelywith the thumbwheel but is not filling in and will not respond to directiona, commands although you still hear the beep.

 

When I slide bell or whistle nothing happens no icon on the remote no engine response.

 

Does anyone know a fix? How do you reset a cab 2? This is version 1.4 and the cab 2 power supply and z1000 are in a grounded outlet.

 

Original Post

Replies sorted oldest to newest

A couple of other things that may help.  You may wish to check that the antenna on the base is firmly attached, is upright and not touching anything.  There is a reset button on the remote. There's a little hole on the underside that you can push a blunt toothpick, straightened paperclip or ballpoint pen into. Don't use anything sharp or too pointed, and don't press too hard, you don't want to damage the switch.

Post
×
×
×
×
Link copied to your clipboard.
×
×