MTH Dispatching Board Doesn't Work

The drive belt will dry out and become too stiff for operation.  That is the first thing I would check.  Two screws on top, two on the bottom and the housing can be removed after pulling the man off.  Replacement belts are available.

Hi Jon.

Thank you for your reply, I removed the top as you advised. The belt is soft and pliable. When I powered it up the belt would not move at all. I hear sounds coming from the top board but there is no movement of the gears on the motor attached to  the belt. I did not feel a vibration coming from the motor. I don't know if the belt does anything more than move the man. the top board moved once without the belt moving.

Any other suggestions would be appreciated.

A few things to check:

-disconnect the drive motor and power it with a DC power source to see if it runs.

-the limit switch in contact with the drive belt could be bad

-the control switch must be depressed long enough for the limit switch to open for proper operation.

-inside the sign, the screws for the bracket holding the worm gear sometimes backs out or the posts break.  In addition, the belt may be slipping.

Jon, it sounds like I have to send it to a MTH approved repair facility. If I start taking things apart I know I will not get it back together correctly.The motor attached to the belt does not move at all. The 2 white gears will not budge.

Please advise if MTH has an approved repair facility near northwest N.J.

I appreciate your help,

I opened the motor that powers the belt and it is not working, that has to be the reason the belt will not move.The top board seems to be working now,it is lighting up and changing as it should.

While you have it opened, blow it out with compresses air.

I removed the gears it turns to make the belt move. That way there was no resistance, made sure it was clean and clear and the motor still does not run.

To locate an authorized service, go to the MTH website under Service and enter your zip code.  I have replacement motors from salvaged dispatch stations.  If you test your motor and it does not work, I can send one for the cost of shipping and handling.  Contact me via the TCA directory.

Hi Jon,

I tested the motor and it does not work.

I am not a member of the TCA and don't have access to the directory.

 You can contact me via my E-Mail,  bobpoline@hotmail.com with the cost for shipping.

 I appreciate your help and generosity and will get a check to you as soon as I hear from you,

 Thank you,

 Bob Poline