i have a fa-2 aba 20-2332-1 and the lights in the cab on both went out the number board lights on both and 1 marker light the red went out. Does any one know the part numbers for these I think why I am in there I will change all the lights even though they are not out yet.
Replies sorted oldest to newest
Before anything else, check to see if the lighting circuit uses springs to bridge the circuit between the chassis and the cab.
If so, make sure that the pads that hold the springs are in their proper places on the posts.
I think so because both front and rear unit headlights light and front green marker lights light ,and both cabs are out and both number boards out red marker is out
I agree with Barry as i took one of my big boys apart a while back and when i carefully reassembled the engine the marker's etc all light went out and i had thought i guided the 4 springs where in the proper place. It only take a spring to be just a little off and the the contact will not be made, i would take apart again and check carefully as you reassemble it!
Good luck!
Alan
I took it apart and back together and still all the same
Did you do a factory reset? They are 6V bulbs. MTH sells a generic one you solder to existing plug, or you can e-mail me and I have bulbs that will work., plus the marker.
I would move a know good bulb to the plug for interior though to see if it works. If not, you have a wire or board FET issue. G
Do you have to work at being a jerk or does it just come naturally?
Do you have to work at being a jerk or does it just come naturally?
Do you have to work at being a jerk or does it just come naturally?
It appears to come naturally based on other threads. 
I am going to check wires out as soon as I get chance. Ggg sent u email on those wires
I have had to clean pads and adjust springs to get lights to work, FWIW.
what does FWIW mean??
Alan
FWIW = For What It's Worth
thanks Barry for the answer
Access to this requires an OGR Forum Supporting Membership
