Skip to main content

I have a MTH SW-1500 MTH #30-2750-1 that the PS-2 is bad. All my other engines are TMCC and I plan to change over from the old PS-2 to ERR's DC commander.  Will the MTH Proto-couplers pigtails plug into the ERR coupler pins? Will the Proto-couplers work with the ERR DC commander?

 

Thanks

Original Post

Replies sorted oldest to newest

Here are some numbers to compare. The MTH connectors have a .1" spacing while ERR and Lionel uses 2mm or .081". 

Lionel/ERR measure 8 ohms. MTH PS2 measure 2.5 ohms. MTH PS1 measure 5.5 ohms.

PS1 couplers would be a better match but I would defer to Bill's experience. The signal to open the couplers is only a short pulse which is likely the reason the R2LC is able to tolerate the lower resistence.

 

Pete

Last edited by Norton

Thanks for all the help on the proto-couplers.  Rock Island we are doing great, I hope you and your family are like wise.

 

If I have problems with the proto-couplers I plan to MU the SW-1500 to a K-Line MP-15 that is a TMCC dummy with Lionel couplers.

 

Thanks again for the help.

Post
×
×
×
×
Link copied to your clipboard.
×
×